Asante EtherPaC 2000+ Series Guide d'installation télécharger pdf (Page 17)

Installing and Configuring the Adapter 2-7

Starting the Setup program

If you’re going to run the Setup program from the hard disk, create a

new DIAG directory on drive C. You can also run Setup from the ﬂoppy.

Insert the ETHERPAC UTILITY AND DRIVERS disk in drive A

or B.

Go to the DIAG directory.

After the DIAG> prompt, enter:

setup <Enter>

The Board Selection Menu appears. Each board in the PC is

identiﬁed in the window (maximum—3).

Figure 2-4

The Board Selection Menu

If the same I/O base address is used on two cards, you have

a conﬂict and must change the I/O base address on one

card.

LAN Adapter Setup Program

Version 2.01 Release Date: June 11, 1993

BOARD SELECTION MENU

Use or to select a board to be diagnosed.

Then press Enter.

Board Type: 16: BIT ISA ADAPTER I/O Base: 0300

Enter = Select ESC = Cancel F1 = Help

If only one board appears above and two or more

are in the PC, then the I/O base addresses on two

boards are the same, resulting in a conflict.

Board Type: 16: BIT ISA ADAPTER I/O Base: 0280

ch 2 Page 7 Monday, August 26, 1996 11:06 AM

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Pas de commentaire

Asante EtherPaC 2000+ Series Guide d'installation Page 17